Home > 996/997 Suspension > QuickChange™ Camber Plate

QuickChange™ Camber Plates

For Porsche 996/997/C2/C4/Turbo

Camber Plates for Porsche 996 and 997

Ease of Adjustment

Elephant Racing's QuickChange™ Camber plates for the front of 996 and 997 cars offer true ease of adjustment. The "slider" design allows a full range of adjustment without the need for removing and rotating the plate for C2, C4, and Turbo models.

More Camber

Range of adjustment is extreme, with 19mm of added travel. This delivers over 2 degrees of added camber, allowing even DOT-R tires and slicks to produce maximum grip.

QuickChange Camber Plate for Porsche 996 and 997 C4 and Turbo Models

QuickChange Camber Plate for C4 and Turbo Models

Pictured above, the Quickchange camber plates are available for 996/997 C4 and Turbo models.  Works with stock-type springs and coilovers.    Will not raise ride height when used with stock-type springs.

Fully Weather Sealed

The included spherical bearings are oversized, maintenance-free, and PTFE lined - they never need lubrication.

Integrated weather seals on both bottom and top of the spherical bearing extend bearing life. Dirt and water enter competing non-sealed products to accelerate bearing wear. Worse yet are bottom-only seals that can actually trap water that enters the open bearing top!

Our weather seals are fully compatible with coilovers and stock type springs.

Use Stock Springs or Coilovers

Fully compatible with stock springs and aftermarket lowering springs. Also supports coilovers that use and upper spring perch.

Higher Performance

Spherical bearings further improve performance. The spherical bearings pivot freely, but eliminate the deflection that is inherent with the factory rubber bushings. This is important for two reasons;

- The factory rubber acts as a spring in series with the strut. This rubber spring-action is completely un-damped and reduces the struts ability to control the tire contact patch. The spherical bearing allows the strut damper to do its job and control the contact patch.

- The factory rubber deflects sideways under cornering loads, causing loss of camber just when you need it most. Our spherical bearings eliminate the deflection, maintaining stable and predictable camber.

Part No. OEM Equivalent Fit Configuration
2152205 '99 - '12 C2 Models
2152210 '99 - '12 C4 and Turbo Models

ORDER HERE - Fill Out Table and Send To Cart

Price

Add

Configure

QuickChange Camber Plates

QuickChange Camber Plates

$

Package Total

$
Elephant Racing on Twitter
Elephant Racing on Instagram
Elephant Racing on YouTube
Elephant Racing on Facebook

+1 408.297.2789 / Fast Shipping Worldwide

© 2004-2017 Elephant Racing LLC, Elephant Racing LLC is not affiliated with Porsche AG